Lang Manufacturing AGC Manual do Utilizador

Lang Manufacturing Company 6500 Merrill Creek Parkway Everett, WA 98203Part Number: 60801- Phone: 425-349-2400 Fax: 425-349-2733 © Copyright 1998W

105. INITIAL START UP5.1 Initial Lighting Procedure for an Clamshell®WARNING:DURING INITIAL USE, OR USE AFTER SERVICE, IF THE PILOT DOESNOT IGNITE ON

116. OPERATION6.1 Clamshell® OperationCAUTION:ALWAYS KEEP THE AREA NEAR THE APPLIANCE FREE FROMCOMBUSTIBLE MATERIALS.CAUTION:KEEP FLOOR IN FRONT OF E

127. SEQUENCE OF OPERATION7.1 Power On• When the Clamshell® is plugged in, 220 Volts is applied to the blower motor. The Clamshell® isdesigned to ha

138. MAINTENANCE & CLEANINGWARNING:KEEP WATER AND SOLUTIONS OUT OF CONTROLS. NEVER SPRAY ORHOSE CONTROL CONSOLE, ELECTRICAL CONNECTIONS, ETC.CAU

149. TROUBLESHOOTING9.1 SymptomsWhat follows is a chart of Symptoms and Possible Causes to aid in diagnosing faults with the Clamshell®.Refer to the

159. TROUBLESHOOTING CONT’D9.2 TESTSNOTICE:Service on this, or any other, LANG appliance must be performed byqualified personnel only. Consult your

1610. PARTS LISTItem No. Part# Description1 103-73 HANDLE2 103-19 HOOD WRAP3 103-193 HOOD SKIRT, LEFT SIDE3 103-194 HOOD SKIRT, RIGHT SIDE3 103-197 H

1710. PARTS LIST CONT’DItem No. Part# Description16 103-61 TUBE #217 80501-10 REGULATOR GAS SET 3 1/2" NG BROILER18 80300-10 MODULE SPARK IGNITOR

1811. WIRING DIAGRAM

1912. WARRANTYLang Manufacturing Limited Warrantyto Commercial Purchasers*(Domestic U.S., Hawaii, & Canadian Sales only.)Lang Manufacturing Equipm

2THIS MANUAL MUST BE RETAINED FOR FUTURE REFERENCE. READ,UNDERSTAND AND FOLLOW THE INSTRUCTIONS AND WARNINGS CONTAINEDIN THIS MANUAL.FOR YOUR SAFETYD

3TABLE OF CONTENTSCHAPTER PAGE1. READ FIRST ...

4 IMPORTANT READ FIRST IMPORTANTNOTICE:If the Clamshell® is to be attached to a griddle/ charbroiler

5IMPORTANT READ FIRST IMPORTANTWARNING:KEEP WATER AND SOLUTIONS OUT OF CONTROLS. NEVER SPRAY ORHOSE CONTROL CONSOLE, ELECTRICAL CONNECTIONS, ETC.CAUT

62. EQUIPMENT DESCRIPTIONLang Model: AGCADD-ON CLAMSHELL® HOOD2.1 Exterior Construction• The Clamshell® dimensions are 19 1/2” (49.53cm) High in the

73. UNPACKING3.1 Receiving the Clamshell®Upon receipt, check for freight damage, both visible and concealed. Visible damage should be notedon the f

84. INSTALLATIONWARNING:INSTALLATION OF THE UNIT MUST BE DONE BY PERSONNELQUALIFIED TO WORK WITH ELECTRICITY AND PLUMBING.IMPROPER INSTALLATION CAN C

94. INSTALLATION CONT’DFigure 1Griddle / CharbroilerACVACVManual Shut-offValveRegulatorLegend:ACV = Automatic Cut-off ValveA = 1” PipeB = Reduction t